Adds a margin over a region of an edge. You can create multiple regional margins along a single edge.
The following example shows two constant margins (displayed in red) and an oblique margin (displayed in yellow) on the plate.
The following example shows a constant margin of -20mm on a profile.
-
You can provide an offset type and distance when using the Along Edge selection method. The software calculates the region based on these properties.
-
You can select a reference plane or surface that does not intersect the selected port when using the Reference selection method. The software places the point on the port after calculating the offset.
-
You can select plates, profiles, seams, and so on that intersect the selected port and provide offset properties when using the Reference selection method. The software calculates the margin end point based on the point of intersection and offset properties.
What do you want to do?