You can follow the basic procedures for installing and setting up HxGN SDx for 3D Project As-Built as described in Application Server Installation and Setup for HxGN SDx, but the 3D Project As-Built installation requires the following specific actions upon reaching these procedures in the installation workflow, as described below.
-
Install HxGN SDx while performing these specific actions:
-
When installing SDx, you must use a 3D Project AsBuilt serial number during the installation of the software.
-
You must install the 3D PAB Starter database component on the server so that you can use it to create a primary site.
-
-
Create a primary site for HxGN SDx while performing these specific actions:
-
After installing the software, when you create a primary site, use the 3D PAB database as the database for the site.
-
After the site has been created in Server Manager, you must create the Graphic Data Model (GDM) schema:
-
Right-click the new SDx site and click Configure GDM3D > Create database schema.
You can also use the Server Manager command line to create the GDM3D schema. For details, see Configure the GDM3D schema from the command line.
-
-