Toolbar:
Specifies the parameters of the body flange.
ANSI flange lookup
Displays the ANSI Flange dialog box.
Description
Specifies an alphanumeric description for the component. This description is visible even when the component is collapsed in the grid.
Length
Specifies the distance from the starting point to the ending point of the component.
Diameter Basis
Specifies either the inside or outside diameter. Select the diameter type from the list.
Diameter
Specifies the diameter of the component based on the Diameter Basis value.
Thickness
Specifies the component thickness.
Flip Orientation
Reverses the orientation of the component.
Material
Displays the Select Item dialog box, which lets you select the material from the list. For more information, see Select Item Dialog Box. The Select Item dialog box uses the file specified by the MaterialFile configuration file variable. For more information, see MaterialFile.
Flange Face ID
Specifies the component inner diameter. See dimension 1.
Flange Face OD
Specifies the component outer diameter. See dimension 2.
Flange Face Thickness
Specifies the component thickness. See dimension 3.
Gasket ID
Specifies the component inner diameter.
Gasket OD
Specifies the component outer diameter.
Gasket Thickness
Specifies the component thickness.
Flange ID
Specifies the component interior flange diameter. If you set this value to zero for a blind flange, the software disables all hub-related boxes. The hub-related boxes are enabled if the Flange ID (D) box has a value greater than zero. See dimension 4
Flange OD
Specifies the component outer diameter. See dimension 5
Flange Thickness
Specifies the component thickness. See dimension 6
Large Hub Thickness
Specifies the component thickness. See dimension 7.
Small Hub Thickness
Specifies the component thickness. See dimension 8
Hub Length
Specifies the distance from the starting point to the ending point of the component. See dimension 9.
Insulation
Displays the Insulation dialog box. For more information, see Insulation Dialog Box.