Toolbar:
Specifies the parameters for the pump base.
This component cannot be created by itself. It must be attached to the following component:
Description
Specifies an alphanumeric description for the component. This description is visible even when the component is collapsed in the grid.
Length
Specifies the distance from the starting point to the ending point of the component.
Width
Specifies the component width.
Height
Specifies the component height.
Start X
Specifies the X-coordinate of the starting point of the pump base. The value is relative to the starting point of the component to which it attaches.
Start Y
Specifies the Y-coordinate of the starting point of the pump base. The value is relative to the starting point of the component to which it attaches.
Start Z
Specifies the Z-coordinate of the starting point of the pump base. The value is relative to the starting point of the component to which it attaches.
Plane
Specifies the plane to which the pump base is parallel. There are three planes available:
-
XY
-
YZ
-
ZX
Rotation Angle
Specifies the pump base rotation angle.