Specifies standard nozzle parameters.
The lists for Diameter, Flange rating, Flange type, and Schedule are populated based on the entries of the NozzleDropDown.TBL file located in the
[Product Folder]\Equipment\System folder.
Nozzle basis
Specifies whether you are using nominal or actual parameters. When you select Nominal, Equipment provides a look-up system for flange dimensions and schedule information.
Diameter
Specifies the diameter of the component.
Schedule
Specifies the schedule rating for the nozzle.
Wall thickness
Specifies the component thickness.
Nozzle extension
Indicates whether a nozzle extension (elbow) is included. Click to display the Nozzle extension dialog box.
Nozzle material
Displays the Select Item dialog box, which lets you select the material from the list. For more information,
see Select Item Dialog Box. The Select Item dialog box uses the file specified by the MaterialFile configuration file variable. For more information, see MaterialFile.
Flange type
Specifies the type of nozzle flange. If you set this value to N/A, then you can manually specify the Flange thickness and Flange OD values. For Flange type values other than N/A, the software uses the dimensions from the FlangeImperial.DAT or FlangeMetric.DAT
file. These files are located in the [Product Folder]\Electrical\System folder.
Flange rating
Specifies the nozzle flange rating.
Flange thickness
Specifies the component thickness.
Flange OD
Specifies the component outer diameter.
Flange material
Displays the Select Item dialog box, which lets you select the material from the list. For more information,
see Select Item Dialog Box. The Select Item dialog box uses the file specified by the MaterialFile configuration file variable. For more information, see MaterialFile.
Thread/Engagement length
Specifies the nozzle end point location. This end point provides a snap location for
any component attached to the nozzle.
Nozzle reinforcing pad
Indicates whether a reinforcing pad exists. Click to display the Nozzle Pad dialog box.
Nozzle Insulation
Indicates whether insulation exists. Click to display the Insulation dialog box.
Applicable Gaskets
Specifies the code to insert a gasket on the nozzle when you add a component containing
Applicable Gaskets or Applicable Bolts in CADWorx Plant. The code that you type in the Applicable Gaskets box must match a code assigned to a gasket in the CADWorx Specification Editor. For more information, see Assign gaskets and bolts to equipment nozzles. You can also find information in the New and Edit Component Pane, and Selection Codes topics in the CADWorx Spec Editor User's Guide.
Applicable Bolts
Specifies the code to insert a bolt on the nozzle when you add a component containing
Applicable Gaskets or Applicable Bolts in CADWorx Plant. The code that you type in the Applicable Bolts box must match a code assigned to a gasket in the CADWorx Specification Editor. For more information, see Assign gaskets and bolts to equipment nozzles. You can also find information in the New and Edit Component Pane, and Selection Codes topics in the CADWorx Spec Editor User's Guide.