Toolbar: 
Specifies the parameters of the cone.
Description
Specifies an alphanumeric description for the component. This description is visible even when the component is collapsed in the grid.
Length
Specifies the distance from the starting point to the ending point of the component.
Diameter Basis
Specifies either the inside or outside diameter. Select the diameter type from the list.
Bottom Diameter (Vertical Cone) or From Diameter (Horizontal Cone)
Specifies the diameter of the component based on the Diameter Basis value.
Thickness
Specifies the component thickness.
Material
Displays the Select Item dialog box, which lets you select the material from the list. For more information, see Select Item Dialog Box. The Select Item dialog box uses the file specified by the MaterialFile configuration file variable. For more information, see MaterialFile.
Top Diameter (Vertical Cone) or To Diameter (Horizontal Cone)
Specifies the cone end diameter.
Concentric
Specifies whether the cone is concentric.
Shell Section
Specifies whether the cone is a shell section.
Cone Length
Specifies the length of the conical portion of the component. This box is only available only if the cone is not a shell section.
Rotation Angle
Specifies the rotation angle of the cone. This box is only available if the cone is eccentric.
Insulation
Displays the Insulation dialog box. For more information, see Insulation Dialog Box.