Delete a reducer - CADWorx - Help

CADWorx P&ID

Language
English
Product
CADWorx
Subproduct
P&ID
Search by Category
Help
CADWorx Version
22
  1. Select a reducer in a drawing.

    Selected Reducer -Delete

  2. Press DELETE.

    The software highlights the line on the reducing (small size) side of the reducer, and then prompts you to change the size of the line.

  • P&ID wont update the line after deleting a reducer if the reducer is within the tolerance of a valve.

  • To change the size of the opposite side of the line, click OppositeSide; the software highlights the line on the other side of the reducer.

    For example, to change the size of the entire line to two inches, do the following:

    1. Click OppositeSide, and then click Yes to change the size to two inch.

    2. Delete the other reducer, click OppositeSide, and then click Yes.

      In the example below, we resized the line to a four inch line.

      Yes No - Delete Reducer

  1. Click Yes.

    The software changes the size of the line and any inline component along the line.

    Delete a reducer line change

  2. Double-click the line to verify the change.

  3. Repeat the steps to delete the other reducer.