Configuring Data Receiving - PAS ICS Integrity - 7.3 - Help - Intergraph

ICS Integrity Help

Language
English
Product
PAS ICS Integrity
Subproduct
ICS
Search by Category
Help
PAS Version
7.3

Use this procedure for step-by-step guidance:

  1. In the Admin Utility on the destination Integrity server, click the Data Receiving link in the Additional Modules section. The Data Receiving window is displayed.

    admin-data-forward-receive

  2. Click Add, and then enter a name for the data receiving schedule and the folder where the data receiving files reside.

    In most cases, you should need a single data receiving schedule to import data from separate sites or plants. In a few cases, you might have multiple schedules to accommodate importing data that is collected at different intervals. If you have more than one schedule for data receiving, make sure to allow enough time for each schedule to complete.

  3. In Data Receiving folder, review the folder specified for the selected asset and make sure the data files (*.CFF and NewFiles.txt) for the data group from the source Integrity installation are in that folder.

    Some assets or object types might forward additional files, such as CSV files.

  4. Click Save.

  5. Click OK on the Data Receiving message window. This message indicates a schedule has been created for importing the data files. By default, the schedule is disabled so you can edit the schedule to run as you want.

  6. Click Schedules in the left pane of the Admin Utility. The data receiving schedule is listed with the name Schedule-data receiving group, where data receiving group is the name of the schedule you defined for data receiving on the destination Integrity installation.

  7. Select the schedule that was created, and then click Edit.

  8. On the General tab, check Enabled.

  9. On the Schedule tab, specify the interval you want to use for importing the data files, and then click OK. By default, the schedule is set to Auto, which means that after you enable the schedule, the import occurs automatically when there is a NewFiles.txt file in the specified data receiving folder.