When you create and save a session file, the settings made using the commands listed below are saved as the default values. These are available the next time you open the session file. The settings are listed and organized based on Smart 3D tasks.
Compartmentation
Place Volume by Two Points Command
Place Volume by Two Points Ribbon options:
-
Type
-
Select Volume (Addition or Subtraction)
-
Volume list
Compartment Properties Dialog Box settings:
-
General tab
Create Imported Volume Command
Create Imported Volume Ribbon options:
-
Type
-
Volume list
-
Select the File
Compartment Properties Dialog Box settings:
-
General tab
-
Place Volume along Path Command
Place Volume Along Path Ribbon options:
-
Type
-
Volume list
Compartment Properties Dialog Box settings:
-
General tab
-
Cross-Section tab
Create Volume by Faces Command
Create Volume by Faces Ribbon options:
-
Type
-
Volume list
-
Face
-
Plate Filter
Compartment Properties Dialog Box settings:
-
General tab
Create Multiple Volumes Command
Create Multiple Volumes Ribbon options:
-
Type
-
Face
-
Plate Filter
-
Bound
Compartment Properties Dialog Box settings:
-
General tab
Bound by Volumes Command
Bound by Volumes Ribbon options:
-
Type
-
Operand list
Compartment Properties Dialog Box settings:
-
General tab
Merge Volumes Command
Compartment Properties Dialog Box settings:
-
General tab
Create Load Combination Command
Create Load Combination Ribbon options:
-
Type
-
Load list
Spatial Load Combination Properties Dialog Box
-
Load General tab
Create Spatial Load Command
Create Spatial Load Ribbon options:
-
Type
Spatial Load Properties Dialog Box settings:
-
Load General tab
Create Unit Load Command
Create Unit Load Ribbon options:
-
Type
Spatial Load Properties Dialog Box settings:
-
Load General tab
Compart Query Service Command
-
Save
Planning
Split Planning Joint Command
Split Planning Joint Ribbon options:
-
Offset
New (Block) Assembly Command
Assembly Properties Dialog Box settings:
-
General tab
Block Properties Dialog Box settings:
-
General tab
Structural Manufacturing
Connect Fabrication Margin Command
Connect Fabrication Margin Ribbon, Fabrication Margin Properties Dialog Box, and Connect Fabrication Margin Ribbon options:
-
Connected Part Filter
-
Part Filter
-
Rule
-
Type
-
Value
Fabrication Margin Properties Dialog Box settings:
-
General tab:
Margin Rule
Type
Value
Active Fabrication Margin Command
Fabrication Margin Ribbon options:
-
Part Filter
-
Rule
-
Mode
-
Type
-
Value
-
Start
-
End
Fabrication Margin Properties Dialog Box settings:
-
General tab:
Margin Rule
Mode
Type
Value
Start
End
Shrinkage Command
Shrinkage Ribbon options:
-
Rule
-
Shrinkage Type
-
Primary Factor Control
-
Secondary Factor
Shrinkage Properties Dialog Box settings:
-
General tab:
Shrinkage Rule
Shrinkage Type
Primary Factor Control
Secondary Factor
Pin Jig Command
Pin Jig Ribbon options:
-
Balance Method
-
Minimum Pin Height
-
Move
Horizontal Offset
Vertical Offset
-
Rotate
Angle
-
Add Pin
Horizontal Offset
Vertical Offset
-
Add Pins
Offset
Part Monitor Command
Part Monitor Ribbon options:
-
View
-
Viewer
Text Format
-
Template
-
Output Format
Manufacturing Service Manager Command
Manufacturing Service Manager Ribbon options:
-
Action
-
Report Per
-
Filter
-
Connected
Selection of Possible Report Data Dialog Box settings:
-
Settings tab:
Only include Out of Date manufacturing objects
Only include manufacturing objects In To Do list
Check detailed part in To Do list
Refresh After Update
Highlight Out of Date objects
Update objects with detailed part in To Do list