-
You cannot use this property if you also use the Primary/Secondary Side Nominal Throat Thickness property. If you selected check box 4, clear it to use this property.
-
The label template uses the default value, Groove Size, from the IJWeldingSymbol property.
-
To create a new label template, do the following:
-
Create a new label in the [Reference Data Folder]\SharedContent\Drawings\Catalog\Labels\Templates\WeldSymbols folder. For information about creating labels, see Create a Label.
-
Select the label template you just created from the Label Template list.
The software does not include Primary Side or Secondary Side in the label template name.
-
Click Save on the Symbol Configuration tab.
The software updates the label template XML as shown below.
Usage in Label Template XML
<contentModuleSettings>
<ID attributeName="PrimarySideGrooveSize"
visible="1">WeldSymbols\
Primary Side Groove Size.rtp</ID><ID attributeName="SecondarySideGrooveSize"
visible="1">WeldSymbols\
Secondary Side Groove Size.rtp</ID></contentModuleSettings>
Primary Side
Specifies the type of groove on the primary side (None, Square, V, Bevel). For the types that can have a bevel (Bevel or V) on this side, the software makes the choice between bevel or none by the presence of a non-zero bevel depth.
Secondary Side
Specifies the actual depth of penetration of the weld. This value is defined as rule-based, but no value is computed. You can set a reasonable value for this based on such factors as material thickness, bevel depth, and so on.