This custom test is for Seam and Knuckle sources in the Actions tab of the Edit Ruleset View Style dialog box.
The Parent Plate test allows you to supply the relationship of the parent plate of the knuckle or seam to the target plate:
-
Not Applicable
-
Splitting the Target
-
Split By Target
-
Bound By Target
-
Bounding the Target
-
Stiffens the Target
-
Edge Reinforcement on Target
-
Target
Without this test, target knuckles or seams on non-target plates cannot be controlled through the rule set view style and can only be identified as target or non-target. For example, the knuckle shown below is classified as target and drawn and labeled, even though it is on a non-target plate and should not be drawn.
1 |
Target plate (the drawn plate) |
2 |
Non-target knuckles |
3 |
Target knuckle on non-target plate |