Reference Curves Ribbon - Intergraph Smart 3D - Administration & Configuration - Hexagon PPM

Intergraph Smart 3D Geometry Analysis and Repair

Language
English
Product
Intergraph Smart 3D
Subproduct
Geometry Analysis and Repair
Search by Category
Administration & Configuration
Smart 3D Version
13

Sets options for placing attributes on a knuckle, tangent, or reference curve.

Select

Select a single wire-body from a graphic view. The existing Name, Symmetry, and Type values appear in their respective boxes when you select the wire-body.

Apply Attributes

Adds the specified properties to the selected object.

Undo Undo

Reverses the operation by replacing the results with the data before the operation was applied. You can modify a setting, re-apply, undo, and repeat until you are satisfied with the results.

Name

Defines a prefix for the wire-body. The complete name is this text value appended by a "_" and the symmetry value: P for Port, S for Starboard, or C for Centered.

Symmetry

Specifies the symmetry to append to the reference curve name.

If the symmetry value is None, the software does not append any value to the name.

If the symmetry value is Port/Starboard, the selected wire-body is named Port, and a copy is created and mirrored about the centerline and assigned a Starboard symmetry value.

Type

Specifies the type of reference curve: a general purpose reference curve, a tangent curve, or a knuckle curve.