Specify the attributes of the concrete attachment plate. Concrete attachment is an optional geometry. These properties are also optional. You must enter values only when the concrete attachment plate is needed.
For these properties, the default unit of distance is mm. Specify in at the end of the dimensional value to use inches (for example 10in).
IJUAhsWidth3::Width3
Specifies the width of the plate. If the value is set to zero or negative, the plate will not be drawn.
IJUAhsLength3::Length3
Specifies the length of the plate. If the value is set to zero or negative, the plate will not be drawn.
IJUAhsThickness3::Thickness3
Specifies the thickness of the plate. If the value is set to zero, the plate will not be drawn. If a positive value is set, then the inside face of the plate will be on the outside face of the base. If a negative value is set, then the outside face of the plate will be on the outside face of the base, so the plate will be embedded into the base. The surface port will always be located on the outward-most face of the plate or base.
IJUAhsOffset3::Offset3
Specifies the left-to-right offset of the plate from the bolt center. If the value is set to zero, the plate will be centered. If a positive value is set, then the edge of the plate will be located the specified distance from the bolt centerline. This value is used when the welded beam attachment bolt part is used for non-symmetrical beam attachments.