You can define properties for four different nuts or washers.
-
Position of Nut 1 is immediately below existing steel
-
Position of Nut 2 is below Nut 1
-
Position of Nut 3 is Gap1 below bottom of pipe
-
Position of Nut 4 is above Nut 3
IJUAhsShape1::Shape1Type
Determines the graphic shape used for the nut or washer using the codelist number defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
The above mentioned codelist values are applicable for Shape2Type, Shape3Type, and Shape4Type as well.
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the nut or washer.
The above mentioned dimensional notation is applicable for Shape2Width1, Shape3Width1, and Shape4Width1.
IJUAhsShape1::Shape1Width2
Specifies the other outside dimension of the nut or washer.
The above mentioned dimensional notation is applicable for Shape2Width2, Shape3Width2, and Shape4Width2.
IJUAhsShape1::Shape1Length
Specifies the thickness of the nut or washer.
The above mentioned dimensional notation is applicable for Shape2Length, Shape3Length, and Shape4Length.