Strap Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

These properties are optional and are used to represent rectangular insulation, U-Bolt-band combinations, or strap-shaped liners, with or without wings. Specify the values for these properties only when strap geometry is required.

IJUAhsStrap::StrapWidthInside (Optional)

Specifies the inside distance between the legs of the strap. This value is greater than PipeOD.

IJUAhsStrap::StrapHeightInside (Optional)

Specifies the inside height from the strap base to the top.

IJUAhsStrap::StrapThickness (Optional)

Specifies the thickness of the rectangular stock used to make the strap. This value cannot be zero.

IJUAhsStrap::StrapStockWidth (Optional)

Specifies the width of the rectangular stock used to make the strap. This value cannot be zero.

IJUAhsStrap::StrapFlatSpot (Optional)

Adds a flat spot in the curved part of the strap. This value can be less than or equal to StrapWidthInside. If set to zero, no flat spot is shown on the curved part of the strap. If set to a positive value, the software adds a flat spot in the curved section of the strap as shown in Figure 1. If set to the same value as StrapWidthInside, the software draws the strap like three plates with no corner rounding as shown in Figure 2.

IJOAhsStrapGap::StrapTopGap (Optional)

Specifies the gap between the outside of the pipe and the inside of the strap.

IJUAhsStrap::StrapWidthWings (Optional)

Specifies the width of the outside wings. If this value is set to zero or to a value that is less than (StrapWidthInside + 2 X StrapThickness), then the strap wings are not shown.

IJUAhsStrap::StrapOneSided (Optional)

Specifies if the strap is one sided or not. If set to Yes, then the right side of the strap is not shown below the tangent point nor are wings, nuts, or gussets included on the right side.

IJUAhsStrap::StrapSplitGap (Optional)

Specifies that there is a gap at the top of the strap and splits the strap into two parts.

IJUAhsStrap::StrapSplitExtension (Optional)

Specifies the length of the tabs from the top inside of the strap to the end of the tabs.