Strap Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

These properties are optional and can be used to represent rectangular insulation, U-Bolt band combinations, or strap-shaped liners, with or without wings. Enter the values for these properties only when strap geometry is required.

IJUAhsStrap::StrapWidthInside (Optional)

Specifies the inside distance between the legs of the strap. This value is greater than PipeOD.

IJUAhsStrap::StrapHeightInside (Optional)

Specifies the inside height from the base of the strap to the top.

IJUAhsStrap::StrapThickness (Optional)

Specifies the thickness of the rectangular stock used to make the strap. This value cannot be zero.

IJUAhsStrap::StrapStockWidth (Optional)

Specifies the width of the rectangular stock used to make the strap. This value cannot be zero.

IJUAhsStrap::StrapFlatSpot (Optional)

Adds a flat spot in the curved part of the strap.

This value can be less than or equal to StrapWidthInside. If it is set to zero no flat spot is shown on the curved part of the strap. If it is set to a positive value, it adds a flat spot in the curved section of the strap as shown in Fig. 1. If it is set to StrapWidthInside the strap is drawn like three plates with no corner rounding as shown in Fig.2.

IJOAhsStrapGap::StrapTopGap (Optional)

Specifies the gap between outside of pipe and inside of the strap

IJUAhsStrap::StrapWidthWings (Optional)

Specifies the width to the outside of the wings.

If this value is set to zero or less than StrapWidthInside plus 2 times the StrapThickness, the strap wings are not shown.

IJUAhsStrap::StrapOneSided (Optional)

Standard Yes or No codelist. If this value is set to Yes, the right side of the strap is not shown below the tangent point.

Wings, bolts and gussets are not included in the right side if StrapOneSided is set to Yes.

IJUAhsStrap::StrapSplitGap (Optional)

Specifies the gap at the top and splits the strap into two parts.

IJUAhsStrap::StrapSplitExtension (Optional)

Specifies the length of the tabs from the top inside of the strap to the end of the tabs.