These properties specify the horizontal bottom plate properties of the welded beam attachment that has a rod hole. If Gap1 = 0, then side and bottom plates are not shown.
IJUAhsWidth2::Width2
Enter the width of the bottom plate. If the value is set to less than Width1, then Width1 is used.
IJUAhsLength1::Length1
Enter the length of the bottom plate. If this value is set to less than Gap1, then Gap1 is used. If this value is set to greater than Gap1, then Thickness2 is subtracted from Height1 of the side plates, and the bottom plate is overlapped with the side plate.
IJUAhsThickness2::Thickness2
Enter the thickness of the bottom plate. Only positive values are acceptable. If this value is set to zero, Thickness1 is used. This thickness is not added to Height1.