These properties specify concrete attachment plate properties. Concrete attachment is an optional geometry setting. Enter these values only when concrete attachment plates are necessary.
IJUAhsLength3::Length3
Enter the concrete plate length. If this value is zero or a negative, the concrete plate is not drawn. However, if SimpShapeType is round, then Length3 is the diameter of the plate.
IJUAhsWidth4::Width4
Enter the plate width. If this value is zero or negative, the concrete plate is not drawn. If SimpShapeType is round, then Width4 is ignored.
IJUAhsThickness4::Thickness4
Enter a positive value for the concrete plate thickness. If this value is zero, the concrete plate is not drawn. The surface port is always located on the upper-most face of the concrete, top, or side plates. This thickness value is not added to Height1.
IJUAhsOffset3::Offset3
Enter the left-to-right offset of the concrete plate from the hole center. If this value is zero, the concrete plate is centered. If this value is positive, the plate edge is located a specified distance from the hole centerline. This value is used when WBA Hole part is used for non-symmetrical beam attachments.
IJUAhsSimpShapeType::SimpShapeType
Specifies the concrete plate graphic shape. The value for this column is a codelist number; valid codes are listed in the HS_S3DParts_Codelist.xls workbook in the hsSimpShapeType sheet. Enter the shortName of the codelist for readability in XLS.
1 - Round
2 - Rectangle