These properties define the geometry of the bottom shape of the beam clamp.
IJUAhsThickness1::Thickness1
Specifies the thickness of the bottom shape.
IJUAhsWidth1::Width1
Specifies the width of the bottom shape.
IJUAhsHeight1::Height1
Specifies the first height of the bottom shape. For shape I, this property will be ignored.
IJUAhsHeight2::Height2
Specifies the second height of the bottom shape. For shape I and shape C, this property will be ignored.
IJUAhsLength1::Length1
Specifies the first length of the bottom shape.
IJUAhsLength2::Length2
Specifies the second length of the bottom shape. For shape I and shape U, this property will be ignored.
IJUAhsRodTakeOut::RodTakeOut
Specifies the distance between the structure port and the RodEnd port. If no value is set to RodTakeOut, then, both, the structure port and the RodEnd port will be aligned on the same horizontal line.
RodEnd port is created only if BottomShape is assigned a defined value.
IJUAhsAngle1::Angle1
Specifies the angle between the structure and the bottom shape. Both, positive and negative values are allowed. It is required only for sloped steel configuration.
This property is applicable only for U shape bottom type.