Base Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

These properties specify the attributes of the horizontal base plate of the welded beam attachment which will be attached to the existing structure. The base plate must be included.

For these properties, the default unit of distance is mm. Specify in at the end of the dimensional value to use inches (for example 10in).

IJUAhsWidth2::Width2

Specifies the width of the base. The value must be positive. If the value is set to zero, the Width1 value will be used by the software.

IJUAhsLength2::Length2

Specifies the length of the base. The value must be positive. If the value is set to zero, then the software sets the value by calculating Gap1 + 2 x Thickness1.

IJUAhsThickness2::Thickness2

Specifies the thickness of the base. The value must be positive. If the value is set to zero, then the Thickness1 value will be used by the software.

IJUAhsOffset2::Offset2

Specifies the left-to-right offset of the base from the bolt center. The value must be positive. The edge of the base will be located the specified distance from the bolt centerline. If the value is set to zero, the base plate will be centered. This value is used when the welded beam attachment bolt part is used for non-symmetrical beam attachments.

IJUAhsGap2::Gap2

Specifies the inside gap between the two side plates. If the value is set to zero, the wings will not be drawn.