IJUAhsClampShape::ClampShape
It is the string specifying the name of the clamp. The clamp name is required for the clamp to be drawn. For more information on clamp shape details, see Clamp Shape.
IJUAhsMulti2::Multi2Qty
Specifies the quantity of clamps. Clamps are not shown when Multi2Qty is set to zero.
IJUAhsMulti2::Multi2LocateBy
Specifies the location of the clamps. Individual clamps can be located in two ways.
1 - Relative to Center of the group
2 - Relative to Edge.
The exact meaning depends on the quantity of clamps. This value can be 0 (nothing), 1 (center), or 2 (Edge).
IJUAhsMulti2::Multi2Location
Specifies the distance for exact location of the clamps depending on Multi2LocateBy and Multi2Qty. This value can be either a distance to the edge, or a center-to-center spacing. For more information on multi position details, see Multi Position.
IJUAhsClampOff::ClampOffset1
Offsets the clamp(s) along the x-axis of the pipe.
IJOAhsClampAngle::ClampAngle
Specifies the angle that a clamp body rotates in counter-clockwise when looking along the positive X direction of the pipe port. ClampAngle overrides Angle3 in the Clamp Shape.
IJUAhsClampWidth1::ClampWidth1
Specifies the width of the lower side of the Clamp.
IJUAhsClampWidth2::ClampWidth2
Specifies the width of the upper side of the Clamp.
IJUAhsClampWidthSel::ClampWidthSel
Specifies the codelist value for the length of the Clamp.
The following values are supported:
1 = Auto - length is based on the length of the Shoe
2 = Input - length is based on the input from the occurrence.
IJUAhsClampLenOvrHng::ClampLenOvrHng
Specifies the overhang for the Shoe length. If the codelist value of IJUAhsClampWidthSel::ClampWidthSel is 1, then the length is based on the length of the Shoe. You can specify overhang and the IJUAhsClampLenOvrHng::ClampLenOvrHng attribute controls the overhang.
IJUAhsClampDiameter1::ClampDiameter1
Specifies the diameter of the Clamp.
IJUAhsClampBoltOff1::ClampBoltOffset1
Specifies the offset for Bolt1 from the center of the Shoe.
IJUAhsClampBoltOff2::ClampBoltOffset2
Specifies the offset for Bolt2 from the center of the Shoe.
IJUAhsClampBoltOff3::ClampBoltOffset3
Specifies the offset for Bolt3 from the center of the Shoe.
IJUAhsClampBoltOff4::ClampBoltOffset4
Specifies the offset for Bolt4 from the center of the Shoe.
IJUAhsClampBoltOff5::ClampBoltOffset5
Specifies the offset for Bolt5 from the center of the Shoe.
IJUAhsClampBoltOff6::ClampBoltOffset6
Specifies the offset for Bolt6 from the center of the Shoe.
IJUAhsClampDiameter4::ClampDiameter4
Specifies the diameter of the Clamp including the liner.
IJUAhsClampWidth4::ClampWidth4
Specifies the length of the liner.