Input Data - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

IJUAhsCC::CC

Specifies the distance between the centerlines of the rods connected to a type G spring.

IJUAhsLoad::Load

Specifies the actual load supported by the constant support.

IJUAhsMovement::Movement

Specifies the amount of thermal displacement of the pipe when moving from the installed (cold) to operating (hot) conditions.

IJUAhsMovementDir::MovementDirection

Specifies the direction of the displacement when moving from the installed to operating conditions. It uses codelist value defined in the hsSpringMovementDir sheet of the HS_S3DParts_Codelist.xls workbook.

IJUAhsTTIncrement::TTIncrement

Specifies the increments between total travels. For example, if total travel goes up in ½ inch increments, set this value to 0.5.

IJUAhsTTIncrementByRule::TTIncrementByRule

Specifies the rule that the software uses to get the total travel increment value. The total travel increment value from the TTIncrementByRule overrides TTIncrement value.

IJUAhsTTUnitType::TTUnitType

Specifies the units of the total travel.

IJUAhsValidTravels::ValidTravelList

Specifies the name of a codelist table that lists all the valid total travel values for the constant support. If you specify a codelist table, then the software selects the total travel value from the list instead of using TTIncrement. Use this for vendors with Total Travel values that do not increase by a consistent value.

Store the total travel as a numeric value in the ShortDescription column of the codelist table.

IJUAhsOverTravelMin::OverTravelMin

Specifies the minimal amount that the total travel must exceed the movement/actual travel.

IJUAhsOverTravelPercent::OverTravelPercent

Specifies the percentage amount that the total travel should be greater than the movement.