These properties are used to create top and bottom pin for the malleable beam clamp.
IJUAhsPin1::Pin1Length
Specifies the length of the inner rod which comes along with the malleable beam clamp. If Pin1Length value is not specified, then the pin is drawn.
If Pin1Length value is less than StructWidth+2*Thickness, then a warning message is displayed and the value is reset to StructWidth+4*Thickness.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the inner rod which comes along with the malleable beam clamp. If Pin1Diameter value is not specified, then the pin is not drawn.
IJUAhsPin2::Pin2Diameter
Specifies the diameter of the pin. This value must be less than the thickness of the clamp. Else, a warning message is displayed. If Pin2Diameter value is not specified, then the pin is not drawn.
IJUAhsPin2::Pin2Length
Specifies the length of the pin. This value must be greater than the depth of the clamp. Else, a warning message is displayed. If Pin2Length value is not specified, then the pin is not drawn.