Snipped Steel Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

These properties specify the Flange and Web modifications when a hanger is snipped by various offset values and angles.

IJOAhsSnipedSteel::CutbackBeginAngle1

Specifies the angle with which the begin face of the flange is snipped.

IJOAhsSnipedSteel::CutbackBeginAngle2

Specifies the angle with which the begin face of the web is snipped.

IJOAhsSnipedSteel::CutbackEndAngle1

Specifies the angle with which the end face of the flange is snipped.

IJOAhsSnipedSteel::CutbackEndAngle2

Specifies the angle with which the end face of the web is snipped.

IJOAhsSnipedSteel::BeginCutbackAnchorPoint1

Specifies the edge for the cutback at the begin face of the flange. The following codelisted values from the CutbackAnchorPoint sheet in the HS_System_Codelist.xls are valid:

  • 2 - Bottom Center

  • 8 - Top Center. BeginCutbackAnchorPoint1 (read-only value)

IJOAhsSnipedSteel::BeginCutbackAnchorPoint2

Specifies the edge for the cutback at the begin face of the web. The following codelisted values from the hsCutbackAnchorPoint sheet in HS_System_Codelist.xls are valid:

  • 4 - Left Center

  • 6 - Right Center. BeginCutbackAnchorPoint2 (read-only value)

IJOAhsSnipedSteel::EndCutbackAnchorPoint1

Specifies the plane for the cutback at the end face of the flange. The following codelisted values from the hsCutbackAnchorPoint sheet in HS_System_Codelist.xls are valid:

  • 2 - Bottom Center

  • 8 - Top Center. EndCutbackAnchorPoint1 (read-only value)

IJOAhsSnipedSteel::EndCutbackAnchorPoint2

Specifies the edge for the cutback at the end face of the web. The following codelisted values from the hsCutbackAnchorPoint sheet in HS_System_Codelist.xls are valid:

  • 4 - Left Center

  • 6 - Right Center. EndCutbackAnchorPoint2 (read-only value)

IJOAhsCutbackOffset::BeginOffsetAlongFlange

Specifies the offset with which the begin face of the flange is snipped.

IJOAhsCutbackOffset::BeginOffsetAlongWeb

Specifies the offset with which the begin face of the web is snipped.

IJOAhsCutbackOffset::EndOffsetAlongFlange

Specifies the offset with which the end face of the flange is snipped.

IJOAhsCutbackOffset::EndOffsetAlongWeb

Specifies the offset with which the end face of the web is snipped.

IJOAhsFacePortOrient::FacePortOrient

Specifies whether the face port orientation is aligned along the flange, or the web when a snip angle is applied. It is a codelisted value from the hsFacePortOrient sheet in the HS_System_Codelist.xls workbook. Allowed values are: 1 - Face Port Orient Along Flange and 2 - Face Port Orient Along Web.