The insulation can have a base or cradle. Not all dimensions are required. If a dimension is blank or equal to zero, the part creates the dimension based on the provided rule. If no rule is provided, the part ignores the dimension.
IJUAhsWidth1::Width1
Specifies the width of the cradle base. This value is optional. If Width1 is equal to zero, then the base graphics are not included.
IJUAhsHeight1::Height1
Specifies the height of the cradle base from the centerline of the pipe. This value is required. If Width1 is greater than or equal to zero, the software ignores Height1.
IJUAhsLength1::Length1
Specifies the length of the cradle base. This value is optional. If Width1 is equal to zero, the software ignores Length1. If Width1 is greater than zero and Length1 is equal to zero, then the base length is equal to Length. Otherwise, the base length is equal to Length1.