IJUAhsTLCorner1::TLCornerType1
Specifies the corner type for the angled notch. TLCornerType1 uses codelist values 2, 3, or 5. See the hsCornerShape sheet from the HS_S3DParts_Codelist.xls workbook for all the valid codes.
Codelist hsCornerShape 2 – Rectangular Notch
IJUAhsTLCorner1::TLCornerX1 -
Codelist Value |
2 |
3 |
4 |
5 |
Corner Type |
XY Chamfer |
XY Edges |
X with an Angle |
Y with an Angle |
X |
||||
Description of X |
Size of chamfer |
Size of straight edge |
Size of chamfer |
Angle from vertical |
Limits of X |
X > 0 |
X >= 0 |
X > 0 |
X > 0 (Angle in degrees) |
X <= Width1 |
X < Width1 |
X <= Width1 |
Calculated X <= Width1 |
IJUAhsTLCorner1::TLCornerY1 -
Codelist Value |
2 |
3 |
4 |
5 |
Corner Type |
XY Chamfer |
XY Edges |
X with an Angle |
Y with an Angle |
Y |
||||
Description of Y |
Size of chamfer |
Size of straight edge |
Angle from vertical |
Size of chamfer |
Limits of Y |
Y > 0 |
Y >= 0 |
Y > 0 (Angle in degrees) |
Y > 0 |
Y <= Length |
Y < Length |
Calculated Y <= Length |
Y <= Lenght |
IJUAhsTLCorner1::TLCornerRadius1
Specifies the radius of the angled notch shape. Use this when the two outside points of the notch must be rounded using the corner radius value. You must set the radius small enough to allow tangents on the top, the left, and the slanted face. If this value is set to zero, then the software draws a sharp corner. This value cannot be negative.