Find documents to publish - Intergraph Smart 3D - Administration & Configuration - Hexagon

Intergraph Smart 3D Integration - SmartPlant Foundation

Language
English
Product
Intergraph Smart 3D
Subproduct
Integration
Search by Category
Administration & Configuration
Smart 3D Version
13.1
SmartPlant Foundation / SDx Version
10

Documents must be up-to-date, and the required Discipline property must be defined in order for the documents to be available for publishing. An error message displays if one or more of the documents found by the Find Documents to Publish command do not meet this criterion. See also Set properties for publishing and sharing documents and Updating Documents.

  1. From the Drawings and Reports task, click SmartPlant > Find Documents to Publish Command.

    • This command is available only if you have registered the model using the SmartPlant 3D Registration Wizard.

    • This feature is also available by clicking the Find button on the Publish Dialog.

    • The Find Documents to Publish command determines which documents need to be published or re-published and displays the results of the search in the Find Documents to Publish Dialog.

    • An error message displays if you have too many unpublished documents in your model. The memory limitation is 4 GB. Make sure that most of the documents in Smart 3D are published, and run the command again.

  2. From the Select documents to publish list, check the boxes that correspond to the documents to publish. You can quickly select the entire list by clicking Select All, or you can clear the entire list by clicking Clear All.

  3. Click OK to accept the selections. The documents selected for publishing now display in the Documents to Publish list on the Publish Dialog and can be saved by publishing the documents. See Publish documents to SmartPlant Foundation.