Specifies the unit format that Isogen uses for pipe bore dimensions.
-
Metric / MM Bores uses millimeter lengths and millimeter pipe bores.
-
Metric / Inch Bores uses millimeter lengths and inch pipe bores.
-
Imperial / Inch Bores uses inch lengths and inch pipe bores.
-
Imperial / MM Bores uses inch pipe bores with lengths in feet and inches.
Defines:
Option Switch - 41, Pos 1
I-Configure - Drawing.Control.Units
-
You can specify the changeover point from where lengths are reported in inches only, to feet and inches.
-
The combination MM bore, FT-IN dimensions is invalid.