-
Select Structural Tab > Primary Beams Command to display the Place Primary Beams Controls.
-
Define the Parent System for the beams.
-
In the Type category box, select the Beam type.
-
In the Type box, select Beam.
-
Set the Cross Section, Material, Cardinal Point, and Angle options as required.
-
Select the elevation planes for the beams.
-
Select Select Columns .
-
Drag a fence around all the columns where you want beams placed. You can drag multiple fences if needed. Drag a fence around previous fence placed columns to remove them. Press BACKSPACE to remove the beams from the last fence.
-
Complete the placement:
-
Select Finish or press CTRL + ENTER to save your changes and exit the command.
-
Select Finish and Modify or press CTRL + SHIFT + ENTER to save your changes, and then start the modification of that object.
-
Select Finish and Repeat or press SHIFT + ENTER to save your changes, and then restart the command using the same options.
-