This procedure can be used when creating a plug-and-socket group for wiring equipment or for modifying an existing plug-and-socket group.
-
To open the Plug-and-Socket Internal Links dialog, do one of the following:
-
When creating a new plug-and-socket group with the Plug-and-Socket Group Wizard, on the Completing the Plug-and-Socket Group Wizard, select View and modify the internal links and select Finish.
-
On an existing plug-and-socket group, right-click and on the shortcut menu select Properties. Select Next until the Completing the Plug-and-Socket Group Wizard page appears, select View and modify the internal links and select Finish.
-
-
To disconnect a link, do the following:
-
On the Plug-and-Socket Internal Links dialog, press the Conn.Mode button to release the button.
-
On the display pane select the link you want to disconnect.
-
You can only select one link at a time.
-
The link turns red when selected, select the link again to clear the selection.
-
Select Disconnect.
-
-
To connect a link, do the following:
-
On the Plug-and-Socket Internal Links dialog, press the Conn.Mode button to select the button.
The cursor changes to a dot (•) over the display pane when the connection mode is selected.
-
Select on the empty pin of the left side connector you want to link from.
-
Select on the empty pin of the second connector (right side) to create the link.
-
-
When you have finished your modifications, select OK.
-
After completing a plug-and-socket group, editing the number of connectors only allows you to increase the number of connectors. You cannot delete existing connectors from the plug-and-socket group.
-
After creating a plug-and-socket group it is not possible to change the total number of connectors from an even number to an odd number of connectors.