This project default specifies the unit of the nominal size for translating the ident description.
Valid values are "in" for inches and "mm" for millimeters.
If the project set to a unit "in" and if the ident description has nominal sizes with the unit "mm", then the nominal size value in the ident description will be searched on S.40.04.01 Nominal Sizes, in the English Metric block, for the corresponding value in DN Metric units. If the value is found, the nominal size in the ident description will be replaced with this value. If the value is not found, the nominal size value in the ident description will be replaced with the string ?.
The same will be done to translate the DN Metric (mm) value to inches (in) when the project default is set to the unit "mm" (using the Metric English block on S.40.04.01 Nominal Sizes).
-
Module(s) affected by this setting: Smart Materials, Smart Reference Data
-
Default value: ./.
-
List of Values: in, mm