This parameter controls the creation of idents during the FIND_IDENT verification job.
Possible values are N (default) and Y.
If this project default is set to N, idents are not built during the FIND_IDENT verification job if no matching ident is found.
If this project default is set to Y, idents are built during the FIND_IDENT verification job if no matching ident is found.
Together with the project default ZS_BLDIDMD, the behavior of FIND_IDENT verification is the following:
-
ZB_BLDIDVJ = N => value of ZS_BLDIDMD is of no relevance.
-
ZB_BLDIDVJ = Y =>
ZS_BLIDIDMD = S Standard build ident is used.
ZS_BLIDIDMD = E Enhanced build ident (using spec header geometrics) is used.
If the position is a CALC item (from line list), then in both cases the build ident procedure for Calc Idents is used.
-
Module(s) affected by this setting: B2001, B200141, B2003
-
Default value: N
-
List of Values: N, Y