This project default specifies whether to validate the ident rule or not.
-
Module(s) affected by this setting: Commodity Rules and Specification Management.
-
List of Values: Y (default) and N.
-
If set to Y, validations are enabled / continued. The existing validations will continue even if the value of this project default is not specified.
These validations include:
-
The type Commodity Code and TAG Number is always included in the ident rule ( Commodity Rules page in SRD).
-
The sizes Size 1..5 are selected in sequence only. You can include Size 2 only after including Size 1 in the ident rule.
-
The attribute characters Attr Char 1..10 are selected in sequence only. You can include Attr Char 2 only after including Attr Char 1 in the ident rule.
-
For example, a commodity code (say, CC1) is built with commodity code rule (say, R1). An Object (say, O1) is associated with the same commodity code (CC1). If object O1 has 5 inputs, then the ident rule (corresponding to R1) must have all the 5 sizes (Size 1..5).
-
The Additional TAG Info tab appears on the Commodity Codes page only if the corresponding commodity code rule also has an ident rule associated with it.
-
You should include the type Output 1..15 in an increasing sequence only. You can include Output 2 only after including Output 1 in the ident rule.
-
-
If set to N, all the above mentioned validations are not performed. You cannot enter the commodity code or tag number in the ident rule. You can include Size 5 even if you have not included Size 1. The number of sizes in the ident rule are not checked with the corresponding object. If ZS_ITA_CHK = N and the tag number field is filled on the Specification Management page, idents are created as per the ident rule defined on Commodity Rules in SRD (if ZS_RBICB = R or not specified). You can include Output 5 even if you have not included Output 1.
-