This parameter controls the creation of idents during the FIND_IDENT verification job.
-
Module(s) affected by this setting: Maintain BOM, Position Details, Advanced Search, Search Results, Procedures/Macros, and BOM Procedures/Macros Logs.
-
List of Values: Y and N (default).
-
If set to Y, idents are built during the FIND_IDENT verification job if no matching ident is found.
-
When ZS_BLIDIDMD = S, a Standard build ident is used.
-
When ZS_BLIDIDMD = E, an Enhanced build ident (using spec header geometrics) is used.
If the position is a CALC item (from the line list), then in both cases the build ident procedure for Calc Idents is used.
-
-
If set to N, idents are not built during the FIND_IDENT verification job if no matching ident is found.
-
When ZB_BLDIDVJ = N, value of ZS_BLDIDMD is of no relevance.
-
-