Draw Arc - Intergraph Smart Production - 20 - Help - Hexagon

Click Arc on the toolbar to display the Draw Arc properties in the State Manager.

Draw Type

Contains commands for specifying how you define the element. The selected type determines which parameters are required to define the element. The available types are listed below.

Three Points

Draws the arc based on the Arc radius and the start point coordinates (X and Y ) and the end point coordinates (X and Y ).

Center Point

Draws the arc based on the center point X and Y coordinates, the Arc radius , the Arc start angle , and the Arc sweep angle .

Tangent

Draws the arc based on the Arc start angle , the Arc radius , and the Arc sweep angle .

Parameters

Arc radius

Specifies the arc radius.

Arc start angle

Specifies the start point of the arc. This value defines the length of the sweep angle.

Arc sweep angle

Specifies the length of the sweep angle. This value defines the length of an elliptical arc.

Center point X,Y

Specifies the X,Y coordinates the center point of the arc.

Start point X,Y

Specifies the X,Y coordinates for the start point of the arc.

End point X,Y

Specifies the X,Y coordinates for the end point of the arc.

Arc Length

Specifies the length of the arc.

Tool

Machining mode

Specifies how the software interprets the elements when you create cutting paths in the Nesting work area. The following modes are available:

• Basic Cutting

• Marking Line

• Marking Point

• Painting

• Ridge

• Info

• Marking Text

• Drilling

Quality class

Specifies the cutting speed to control the cutting quality.

Part layer

Specifies whether the software uses the inner profile. The following options are available:

• Normal

• NotMirrored

• Mirrored