Introduction - Intergraph Smart Reference Data - Version 10.2 - Customization & Programming - Hexagon

Intergraph Smart Reference Data Integration (10.2)

Language
English
Product
Intergraph Smart Reference Data
Search by Category
Customization & Programming
Smart Materials/Smart Reference Data Version
10.2

You can configure the settings, integrate the Plant Design Management System (PDMS)/ E3D data in to Smart Reference Data (SRD), and then transfer the required information to PDMS/ E3D interface. Data can be transferred to PDMS/ E3D in two steps as follows:

  1. Ident transfer

  2. Specification transfer

If the ident files are already available in PDMS/ ED3 interface, you need not transfer them again. Some steps are the same for both kind of transfers, while some are only for one type of transfer.

The transfer generates a set of ASCII files that can be separated into one file for the specifications (SPECON File ) and a set of files for the ident transfer.

Idents can be exported to the PDMS/ E3D software using specific file formats. We have the following three main file formats:

  • Data: It contains all the ident related information that are exported.

  • Delete: It contains information related to the data deleted from the destination.

  • Error: It contains information related to the error in the exported data.

When you export, the ident information is stored in more than one file such as:

The specification file is generated based on the configurations made in the Data Table Configurations page in SRD.

All nodes at all level are unique in PDMS/ E3D. The uniqueness is not defined at tree node level but across all tree path and nodes.

To learn more about different PDMS/ E3D output formats, see PDMS/ E3D Output Formats.