General Configs - Intergraph Smart Reference Data - Version 10.2 - Customization & Programming - Hexagon

Intergraph Smart Reference Data Integration (10.2)

Language
English
Product
Intergraph Smart Reference Data
Search by Category
Customization & Programming
Smart Materials/Smart Reference Data Version
10.2

Usually it is sufficient to create a general config once during the setup of the interface. If it’s necessary to edit the config, you can do it on the CADWORX 10.01 General Configs screen.

The following config items are used in the CADWorx interface:

  • AUTO_SELECT_IDENTS_FROM_SPEC – When a spec/spec items are selected on CADWORX 20.01, should the used groups/parts/commodity codes also be selected for transfer? The auto selection takes place during the export job validation. As CADWorx does not receive the ident level, it is recommended to opt for COMMODITY or COMMODITY_REPLACE.

  • AUTO_SELECT_SHTS_FOR_PARTS - Fill the assigned component data sheets into the job sheet selection, if the related commodity codes were selected? This feature can be used to select component data sheets dynamically based on the participating components.

  • NEW_RUN_JOB_GOAL - A fixed job goal can be preselected if a run is created using the New Run button on CADWORX 20.01. If nothing is entered, the new run will use the goal of the previous run.

  • SI_PIPING_SHORT_CODE_LST - Comma separated list of the short codes which should be considered as piping. Each value must be enclosed in single quotes. The list is evaluated when the piping items are exploded to ident granularity. See SI_SCHEDULE_MTHD_PIPING config item.

  • SI_SCHEDULE_MTHD_PIPING - The schedule method for piping items in the SPEC_ITEM_FILTER sheets. If the piping schedule is not contained in the commodity code, the (default) option GEOMETRIC is recommended. Alternatively it is possible to create a separate specification item as soon as a piping element has a different schedule, and use the CADWORX 10.04 to map the schedule for each piping specification item. For example, instead of having one specification item for pipe from 4 to 20 inches, have two lines: One from 4 to 6 inches (schedule S-XS) and another one from 8 to 20 inches (schedule S-STD).

  • SI_SCHEDULE_MTHD_NONPIPING - The schedule method for non piping items (flanges, valves, and so forth) in the SPEC_ITEM_FILTER sheets.

  • SI_TRANSLATION_LEVEL - The translation level for specification items defines the resolution in sheets of the SPEC_ITEM_FILTER category. COMMODITY is the default.

  • VERIFY_CONSISTENCY - Check the quality of exported data? This check takes place directly after the interface tables have been filled, and the verification belongs logically to the export job stage FILL_IF_TABS. Verification is not required to proceed with further steps of the job, and also verification alerts can be ignored. As per initial delivery there are no check routines delivered for CADWorx.