In this module, you can view the list of spool numbers for the selected drawings and the number of welds in a spool for which Fit-Up Verification, Visual Inspection, and NDT inspection stages are completed.
You can release the spool, only when the following two conditions are satisfied:
-
Fit-Up Verification and Visual Inspection are completed for all the welds (Total Welds) in a spool.
-
All the welds for which the NDTs are selected for the spool must be completed.
For example, as shown in the figure below, the total number of welds for a spool must match with the total number of welds that have completed Fit-Up Verification and Visual Inspection. Also, the total number of welds selected for NDTs in a spool must be completed.
-
To view the spools data in this module, you must load the data for piping welds in Welds module.
-
The welds for which the property Is NDT Required is set to Y (Yes) and are accepted in Visual Inspection are displayed in the NDT Selected field.
To view the spools data for the drawing:
-
Click Spool Status module.
-
From the list, select any filter criteria. For example, select Spool Number.
-
Enter * and click Refresh .
The software displays the ISO/Drawing numbers that satisfy the filter criteria.
-
Select a drawing number from ISO/Drawing No: list.
The software displays the list of spool numbers for the selected drawing.
-
Select the spool number and click Release Spool .
The Release Spool button is enabled only if the total number of welds for the selected spool match with the total number of welds that have completed Fit-Up Verification and Visual Inspection.