Although both methods described below use the Detail Sketch Browser to place the detail sketch in the isometric drawing, the recommended and most direct method is Method 1.
Method 1
-
Select Add > Detail Sketch or select Place Detail Sketch
on the Place toolbar.
-
Select a component in the model on which to place the detail sketch to open the Detail Sketch Browser.
The Detail Sketch Browser opens.
-
Select a style in the Style list on the horizontal toolbar.
The software extracts the path to the detail sketch folder from the style, and populates the list with the detail sketches available for the selected style.
See Detail Sketch Manager in the ISOGEN Configuration Help.
-
Select a detail sketch in the list.
The software displays a graphical view of the selected detail sketch in the viewing area.
-
If necessary, use the Search box to limit the list of available sketches.
-
Only .dwg, .igr, and .sym (.sha) file types are fully supported by the software.
-
-
Select OK to close the Detail Sketch Browser and return to the model.
The software places a detail sketch identifier, designated by DSI and the detail sketch filename, next to the selected component.
Method 2
-
Select Add > Annotation or select Place Info
on the Place toolbar to display the Selection ribbon.
-
On the Selection ribbon, select Detail-Sketch-Identifier in the Type list.
-
Select a component in the model on which to place the detail sketch, and then select Detail Sketch Browser
on the Selection ribbon to open the Detail Sketch Browser
-
Select a style in the Style list on the horizontal toolbar.
The software extracts the path to the detail sketch folder from the style, and populates the list with the detail sketches available for the selected style.
See Detail Sketch Manager in the ISOGEN Configuration Help.
-
Select a detail sketch in the list.
The software displays a graphical view of the selected detail sketch in the viewing area.
-
If needed , use the Search box to limit the list of available sketches.
-
Only .dwg, .igr, and .sym (.sha) file types are fully supported by the software.
-
-
Select OK to close the Detail Sketch Browser and return to the model.
-
Select OK
on the Selection ribbon.
The software places a detail sketch identifier next to the selected component.
-
To re-open the Detail Sketch Browser and edit the detail sketch, right-click the detail sketch identifier in the model, and then select Edit Detail Sketch.
-
When you generate the isometric drawing, the resulting detail sketch output resembles the example below. The parameters for the direction and angle that are displayed in the detail sketch are defined using ISOGEN Configuration in I-Configure. See Configure a Detail Sketch in the ISOGEN Configuration Help.
-
A third method for placing detail sketches is also available. However, because this method does not use the Detail Sketch Browser, it provides little control over detail sketch placement. Select Place Info
on the Place toolbar, and then select Detail-Sketch-Identifier in the Type list. Next, type a name for the detail sketch in the Identifier box, and then select OK on the Selection ribbon to place the detail sketch identifier.