The following properties are applicable to Braced Cantilevers.
IJUAhsBraceAngle::BraceAngle - Specifies the angle at which the brace is connected to the structure. BraceAngle accepts only positive values less than or equal to 60 degrees.
IJUAhsBraceHorOff::BraceHorOffset - Specifies the distance by which the brace is offset horizontally from the edge of the plate.
IJUAhsBraceOffDef::BraceOffsetDef - Specifies how the BraceHorOffset is measured. The following values are allowed:
-
1 - From the edge of the horizontal member to the Brace end.
-
2 - From the center of pipe to the Brace end
-
3 - From edge of pipe to Brace end
-
4 - From edge of horizontal member to intersection of centerlines
-
5 - From center of pipe to intersection of centerlines
-
6 - From edge of horizontal member to inner edge of brace end