Cantilever Weld Tables - Intergraph Smart Reference Data Standard Database - Version 12.3 - Help - Hexagon PPM

SDB for SRD Hangers and Supports Help 12.3

Language
English
Product
Intergraph Smart Reference Data Standard Database
Search by Category
Help
Smart 3D Version
13
Standard Database for Smart Reference Data Version
12.3

Each cantilever support excel sheet has a corresponding Excel sheet for welds. The weld sheets specify the weld parts that are added to the support and their location. The weld parts are then included in the drawings.

  • Each support has a predefined number of connections for which the welds are specified.

  • Each connection has a number of predefined locations for the welds and location specifies the placement of the weld object for a specific connection. The weld annotation leader points to this location in the fabrication drawing.

You can add multiple welds to a single connection, each weld with a different location. If the predefined locations do not allow you to place a weld at the required position in the support, you can specify rules to offset the weld object in the X, Y, and Z direction. These directions are defined for each connection.

Weld Excel Sheet Design

Weld Excel Sheet Design

The weld Excel sheet name consists of two parts, the support sheet name followed by '_Welds'. For example, if the support Excel sheet name is BM, then the weld sheet name is BM_Welds.

A weld sheet has the following columns:

Name

Specifies a unique name for the weld.

SupportPartNumber

Specifies the catalog support part number to which the weld is added.

WeldPartNumber

Specifies the catalog part number for the weld.

Connection

Specifies the connection on which the weld is placed. For permissible connections for a support, see the related support content in this guide.

Location

Specifies the location at which the weld is placed with respect to a connection. For permissible locations for a support, see the related support content in this guide.

OffsetXValue or OffsetXRule

Specifies the value or the rule that defines the offset for the weld in the X direction. The rule takes a higher precedence if both the rule and the value are specified.

OffsetYValue or OffsetYRule

Specifies the value or the rule that defines the offset for the weld in the Y direction. The rule takes a higher precedence if both the rule and the value are specified.

OffsetZValue or OffsetZRule

Specifies the value or the rule that defines the offset for the weld in the Z direction. The rule takes a higher precedence if both the rule and the value are specified.

Connections

For each weld added in the weld table, there is a connection key that specifies its connection. Valid values are based on the cantilever type.

Multiple connections can be added to a single connection at different locations.

Cantilever (hsIFrameWeldConnection service class)

Braced Cantilever (hsBCWeldConnection service class)

Locations

Each connection has four predefined locations: 2, 4, 6, and 8.

These predefined locations are similar to the cardinal points on steel cross-sections, and control the weld location object in the weld plane. The three offset rules can be used to offset the weld object from the predefined location. Additional locations can also be added as required. Allowed values are specified in the hsFrameWeldLocation codelist in the HS_S3DSupports_Codelist.xls workbook.

Location for Plates

Each location refers to a separate edge of the plate.

Offsets

The three offset rules, OffsetXRule, OffsetYRule, and OffsetZRule, are the hanger rule names. These rules are responsible for returning the required offset value to the specified location. The offset rules are necessary only if none of the predefined locations meet the requirements. You can also specify a numerical value in the Value column.