The following attributes specify the Bolt configuration attributes of an Adjustable Base Support:
|
Attribute Name |
Description |
Implementation Details |
|---|---|---|
|
IJUAhs_ABSBoltOffsetZDef:: BoltOffsetZDefinition |
Specifies how the Bolt Z offset must be measured. |
Use the following values: 1 = Bottom of the Bolt to the Top of Plate or Structure
|
|
IJUAhs_ABSBoltOffsetXDef:: BoltOffsetXDefinition |
Specifies how the Bolt X offset must be measured. |
Use the following values: 1 = Edge of Plate to Center of Bolt
2 = Edge of Plate to Center of Bolt
3 = Edge of Plate to Center of Bolt
|
|
IJUAhs_ABSBoltOffsetYDef:: BoltOffsetYDefinition |
Specifies how the Bolt Y offset must be measured. |
Use the following values: 1 = Edge of Plate to Center of Bolt
2 = Edge of Plate to Center of Bolt
3 = Edge of Plate to Center of Bolt
|
|
IJUAhs_ABSCylinder::CylinderPart |
Specifies the Pipe Section part number for the support. The part number specified must be a RichHgrBeam implemented using HgrStructuralLib.RichHgrBeam |
|
|
IJUAhs_ABSCylinderRl::CylinderPartRule |
Specifies the hgrSupportRule that returns the part number for the cylinder. The hanger rule must be the name of an existing rule in the catalog. |
|
|
IJUAhs_ABSBottomPlt::BottomPlate |
Specifies the Bottom Plate part number for the support. The part number specified must be a Plate implemented using HS_S3DPlate.TwoStandardPort |
|
|
IJUAhs_ABSBottomPltRl::BottomPlateRl |
Specifies the hgrSupportRule that returns the part number for the Bottom plate. The hanger rule must be the name of an existing rule in the catalog. |
|
|
IJUAhs_ABSLug::ShearLug |
Specifies the Lug part number for the support. The part number specified must be a Plate implemented using HS_S3DPlate.TwoStandardPort |
|
|
IJUAhs_ABSLugOff::LugOffset |
Specifies the offset of lug from edge of plate. |
|
|
IJUAhsInsLength::Length |
Specifies the length of the support. |
|
For more information about how to use the dimensional attributes, see Input Values.