The following dimensions are used only by the SmartPart Base Plate data-driven assembly:
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
BasePlateLength |
Base Plate Length |
Dimensions |
Yes |
No |
BasePlateLengthRule |
Base Plate Length Rule |
Dimensions |
No |
Yes |
BasePlateWidth |
Base Plate Width |
Dimensions |
Yes |
No |
BasePlateWidthRule |
Base Plate Width Rule |
Dimensions |
No |
Yes |
BasePlateThk |
Base Plate Thickness |
Dimensions |
Yes |
No |
BasePlateThicknessRule |
Base Plate Thickness Rule |
Dimensions |
No |
Yes |
BasePlateOffset |
Base Plate Offset |
Dimensions |
Yes |
No |
BasePlateOffsetRl |
Base Plate Offset Rule |
Dimensions |
No |
Yes |
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsBasePlateLength:: |
A numerical value for the base plate length. |
The CustomInterfaces sheet has the default units. This sheet exists in AllCodeLists.xls. Otherwise, specify the below mentioned units:
|
IJUAhsBasePlateLengthRl:: |
Specifies the HgrSupportRule that returns the value for base plate length. The hanger rule must exist in the catalog, and must be the name of a rule. To select the base plate length using BasePlateLength, do not specify any value for this property. |
For example: Rule Name: BasePlateLenBySize Rule ProgID: HS_S3DRules, HS_S3DRules. |
IJUAhsBasePlateWidth:: |
Specifies a numerical value for the base plate width. |
The CustomInterfaces sheet has the default units. This sheet exists in AllCodeLists.xls. Otherwise, specify the below mentioned units:
|
IJUAhsBasePlateWidthRl:: |
Specifies the HgrSupportRule that returns the value for base plate width. The hanger rule must exist in the catalog, and must be the name of a rule. To select the base plate width using BasePlateWidth, do not specify any value for this property. |
For example: Rule Name: BasePlateWidthBySize Rule ProgID: HS_S3DRules, HS_S3DRules. |
IJUAhsBasePlateThk:: |
A numerical value for the base plate thickness. |
The CustomInterfaces sheet has the default units. This sheet exists in AllCodeLists.xls. Otherwise, specify the below mentioned units:
|
IJUAhsBasePlateThkRl:: |
Specifies the HgrSupportRule that returns the value for base plate thickness. The hanger rule must exist in the catalog, and must be the name of a rule. To select the base plate width using BasePlateThickness, do not specify any value for this property. |
For example: Rule Name: BasePlateThkBySize Rule ProgID: HS_S3DRules, HS_S3DRules. |
IJUAhsBasePlateOffset::BasePlateOffset |
Specifies the distance by which the base plate can be offset from primary pipe. |
|
IJUAhsBasePlateOffsetRl::BasePlateOffsetRl |
Specifies a rule to get the BasePlate offset. |
If you specify a value, the software gets the ‘BasePlateOffset’ using rule. |