A Gusset support uses the following configuration properties:
Name |
User Name |
OA |
Category |
On Property Page |
Read Only |
---|---|---|---|---|---|
AngleUp |
Gusset - UP Angle |
Yes |
Dimensions |
Yes |
No |
AngleSide |
Gusset - Side Angle |
Yes |
Dimensions |
Yes |
No |
FlangeWidth |
Flange - Width |
Yes |
Dimensions |
Yes |
No |
FlangeCon |
Flange - Connection Type |
Yes |
Dimensions |
Yes |
No |
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJOAhsGuAngleUp:: |
Specifies the angle at which the Gusset parts are skewed around the branch pipe. |
Supported values are: 0 < A < 90 degrees |
IJOAhsGuAngleSide:: |
Specifies the angle at which the Gusset parts are skewed around the branch pipe. |
Supported values are: 0 < A < 90 degrees |
IJOAhsGuFlangeWidth:: |
Specifies the flange width that the Gusset parts are offset from the branch pipe centerline. If the value is 0 (zero), the flange width is not used as offset by the Gusset parts. Instead, half the diameter of the branch pipe is used. |
|
IJOAhsGuFlangeCon:: |
Specifies the codelist value that defines how the edge of a Gusset is connected to the Flange. |
hsGussetOnFlange 1 = Flange Face 2 = Flange Side |