The Repad support assembly uses the following input dimensions:
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhs_RepadLength:: |
Specifies the Repad length |
The following definition is supported: 1 - Direct - Specifies direct measurement |
IJUAhs_RepadThk:: |
Specifies Repad thickness. |
The following definition is supported: 1 - Direct - Specifies direct measurement |
IJUAhs_RepadAngle:: |
Specifies the angle at which the Repad is placed on the pipe. |
The following definitions are supported: 1 - Clockwise - The angle is measured by moving the Repad in clockwise direction starting with 0, being the bottom of the pipe. 2 - Anticlockwise - The angle is measured by moving the Repad in counterclockwise direction starting with 0. 0implies bottom of the pipe. |
IJUAHS_RepadAngleDim:: |
Specifies the sweep angle of the repad shape. |
The following definition is supported: 1 - Pipe Center to Bottom |