Configuration Attributes - Intergraph Smart Reference Data Standard Database - Version 12.4 - Help - Hexagon

IJUAhs_LugDblSpace::
LugDblSpace

Specifies the offset value for adding a second lifting lug.

1 - Space between Lifting Lug inside edges

IJUAhs_LiftingLugGap::
LiftingLugGap

Specifies a value for the gap between the pipe and the Lifting Lug. The Lifting Lug is offset by this value.

1 - Space between pipe and Lifting Lug inside edges

IJUAhs_RepadPart::RepadPart

Specifies the Repad part number or part class to use for the support.

IJUAhs_RepadRl::RepadRule

Specifies the HgrSupportRule that returns a Repad part for the support.

IJUAhs_RepadTh::
RepadThickness

Specifies the total thickness of the Repad.

Default units are specified on the CustomInterfaces sheet. Specify the units otherwise.

IE:
10
10mm
1in

IJUAhs_RepadThRl::
RepadThicknessRule

An HgrSupportRule that returns a numerical value for RepadThickness. The Hanger Rule should be present in the catalog; it can be a rule Name or ProgID.

If you intend to use RepadThickness to directly specify the length, then this attribute should be left blank.

IE:
Rule Name:

RepadThFromPipeWall

Rule ProgID:

HS_S3DRules. RepadThFromPipeWall

IJUAhs_RepadThSel::
RepadThicknessSelection

Determine which attribute is used to set RepadThickness. If no value is given, the RepadThickness attribute will be used by default.

If the Dummy is being used as a sub assembly, check to see if the RepadThicknessOverride attribute has been set by the parent assembly.

hsSelection

1 = By Rule
Get RepadThickness from RepadThicknessRule

2 = By Input
Use value from RepadThickness attribute

IJUAhs_RepadThDef::
RepadThicknessDefinition

The definition of the RepadThickness value. This attributes specifies how the attachment should be measured.

If a value is set for RepadThickness but no definition is given, an error will occur.

Supported Values

1 = Repad Thickness (direct)