The following attributes are used to configure the secondary supports:
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsTrunOH:: Overhang IJUAhsTrunOH2:: Overhang2 |
Specifies the overhang to overwrite the Trunnion sub-assembly. |
|
IJUAhs_ShoeLength:: ShoeLength |
Specifies the length of the Shoe. |
|
IJUAhs_ShoeHeight:: ShoeHeight |
Specifies the space between the Structure and the Trunnion supports. |
If you do not specify a value or set the value to 0, the software calculates the shoe height from the sub-assembly information. |
IJUAhsUBoltOffset:: UBoltOffset IJUAhsUBoltOffset2:: UBoltOffset2 |
Specifies the position of the bolt offset. |
Use the following definitions: 1 - End of trunnion 2 - End of cap plate 3 - Edge of pipe 4 - Center of pipe 5 - Structure face (toggle structure/face)
|
IJUAhsTrunAngle1:: TrunnionAngle1 IJUAhsTrunAngle2:: TrunnionAngle2 |
Specifies the angle of rotation for each trunnion leg about the pipe. |
Applicable for trunnions on a straight pipe. |
IJUAhsGuideGap:: GuideGap |
Specifies the guide gap to the left side of the pipe. |
Applicable only if a guide support is available. |
IJUAhsGuideGap2::GuideGap2 |
Specifies the guide gap to the right side of the pipe. |
Applicable only if a guide support is available. |
IJUAhsStopGap:: StopGap |
Specifies the guide gap. |
Applicable only if a stop support is available. |