The Stanchion assembly uses the following attributes:
|
Name |
User Name |
Category |
On Property Page |
Read Only |
|---|---|---|---|---|
|
StanchionAngle |
Stanchion Angle |
Dimensions |
Yes |
No |
|
OffsetFromStructure |
Offset From Structure |
Dimensions |
Yes |
No |
|
StanchionGap |
Stanchion Gap |
Dimensions |
Yes |
No |
|
StanchionLength |
Stanchion Length |
Dimensions |
Yes |
No |
|
Attribute Name |
Description |
Implementation Details |
|---|---|---|
|
IJUAhsStanchionAngle:: |
Specifies the orientation of the stanchion support along its vertical axis. |
Use the following values: Steel Member - Angle = 0 or 180
Steel Member - Angle = 90 or 270
|
|
IJUAhsStanchionOffset:: |
Specifies the offset from the face of the supporting object. This attribute value must be applied below the bottom most part of the support. |
|
|
IJUAhsStachionGap:: |
Specifies the gap between the route and the top of the stanchion. If you specify a value for stanchion length, the software does not use the stanchion gap value. If you do not specify a value for stanchion gap or for stanchion length, the software uses the part attributes. |
Use the following definitions: 1 = Pipe centerline - Horizontal pipe
2 = Bottom of pipe - Horizontal pipe
3 = Top of turn
4 = From SmartPart StanGap attribute |
|
IJUAhsStanchionLength:: |
Specifies the length of the stanchion. If you specify a value for stanchion length, the software does not use the stanchion gap value. |
Use the following definitions: 1 = Bottom to top of support (includes all parts)
2 = Bottom of base plate to top of support
3 = Bottom of SmartPart to top
|
|
IJUAhsCapPltPt::CapPlatePart |
Specifies the Cap plate of the stanchion support. |
|
|
IJUAhsCapPltRl::CapPlateRule |
Specifies the rule to get the Cap plate from the auxiliary table. |
|
|
IJUAhsStiffener::StiffenerPart |
Specifies the Stiffener plates of the stanchion support. |
|
|
IJUAhsStiffenerRl::StiffenerRule |
Specifies the rule to get the Stiffener plate from the auxiliary table. |
