The following dimensions are used by the Guide sub-assembly:
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
GuideGap |
Guide Gap |
Dimensions |
Yes |
No |
GuideGap2 |
Guide Gap 2 |
Dimensions |
Yes |
No |
GuideDirection |
Guide Direction |
Dimensions |
Yes |
No |
PlateLength |
Plate Length |
Dimensions |
Yes |
No |
PlateWidth |
Plate Width |
Dimensions |
Yes |
No |
GuideAngle |
Guide Angle |
Dimensions |
Yes |
No |
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsGuideGap:: |
Specifies the gap for the guide. This applies to East and South guides. |
|
IJUAhsGuideGap2::GuideGap2 |
Specifies the gap for the guide. This applies to West and North guides. |
|
IJUAhsGuideDirection:: |
Specifies a codelisted value for the direction of the guide. |
The following codelist values are supported: 1: North/South 2: East/West 3. North/South/East/West 10:None |
IJUAhsPlateLength:: |
Specifies the length of the plate for the guide. |
|
IJUAhsPlateWidth:: |
Specifies the width of the plate for the guide. |
|
IJUAhsGuideAng:: |
Specifies the angle to rotate the guides around their center point. |
|
IJUAhsGuideLength:: |
Specifies the length of the guide. If you are using a SmartPart Guide, then either Thickness2 or Length2 must be an occurrence attribute on the guide part. These attributes allow you to modify the length depending on the SecConfig attribute on the guide part (Vertical or Horizontal). If you are using a SmartPart Plate, then the length cannot be modified using this attribute. If you are using a RichHgrBeam part, then this attribute only modifies the steel length. |
If the guide is horizontal: If the guide is vertical: |