Use the following attributes to define the Stanchion support:
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsDummyVarHeight:: |
Specifies a codelist for the secondary part. The secondary part must have a variable height. |
Use the following values: 1 - DummyLeg 2 - Stanchion 3 - AdjustableBase |
IJUAhsDummyLength:: |
Specifies the length of the Dummy Leg depending on the DummyLengthStart and the DummyLengthEnd attributes in the secondary support. |
Leave this option blank if the Dummy Leg is a variable height support. |
IJUAhsCmbDummyLen |
Specifies the Dummy Length. |
Use the following definitions: 1 - Length of the dummy 2 - Length of the dummy - ABS Height To use this attribute, you must specify ABS for definition 2. Do not set the Dummy Leg to a variable length. |
IJUAhsABSGap::ABSGap |
Specifies the gap in the Adjustable Base Support depending on the PlateSpacingDefinition of the secondary support. |
If the adjustable base has a variable height, leave this attribute blank. |
IJUAhsStanchionLength:: |
Specifies the length of the stanchion base depending on the length definition of the secondary support. |
If the stanchion has a variable height, leave this attribute blank. |
IJUAhsStructureOffset:: |
Specifies the offset from the structure to the bottom of the support. |
|
IJUAhsGuideQty:: |
Specifies the quantity of guide supports. If you set the value to zero or leave this attribute blank, the software does not include the guides in the support. |
|
IJUAhsGuideGap:: |
Specifies the gap between Guide1 and left side of the respective plate. |
|
IJUAhsGuideGap2::GuideGap2 |
Specifies the gap between Guide 1 and right side of the respective plate. |
|
IJUAhsGuide2Gap:: |
Specifies the gap between Guide2 and the respective plate. This attribute is valid only when the GuideQty is set to a value greater than one. |
|
IJUAhsGuideAng:: |
Specifies the angle at which guides are attached to the Dummy Leg. |
|
IJUAhsMovementLocation:: |
Specifies the codelist value for the bottom most movable support. If the support has the Guide and Slide plate, the software places them at the bottom of the support. |
Use the following values: 1 - DummyLeg 2 - Stanchion 3 - AdjustableBase |
IJUAhsIncludeGrout:: |
Specifies a boolean value to determine whether a Grout part is included in the support. |
If you use a Grout support, instead of a Grout part in either a Stanchion or a Dummy Leg support, the software includes only the Base plate and the Anchor Bolts of the Grout support. |
IJUAhsGroutThickness:: GroutThickness |
Specifies the thickness of the Grout part used in the Stanchion or the Dummy Leg, if included. |
|
IJUAhsGroutAngle:: |
Specifies the angle of the grout edge that determines the bottom width. |
|
IJUAhsBoltLength:: |
Specifies the length of the anchor bolts. This attribute is valid only for variable length anchor bolts as you cannot adjust fixed length bolts. |